DIY Chalkboard Subway Sign – a Restoration Hardware Knockoff
Create an easy, Restoration Hardware knockoff DIY chalkboard subway sign from an old framed thrift store print, paint, and chalk for a fraction of the price!
Yield: 1 chalkboard
Calories:
Cost: $2
Equipment
- Pencil
- Ruler
- 1-inch paint brushes and small artist brush
- Painters Tape
- White chalk marker
- Printer to print out letters (if you can hand draw them, go for it)
Materials
- 1 Framed thrift store print Look for one where the image is usually very muted and it’s printed directly on a type of pressboard which seems almost one piece with the frame – there is no space visible between the frame and the print. This lack of space between frame and backing/print makes them ideal for painting (an old cupboard door in a similar shape would be good, too).
- White enamel interior paint or craft paint
- Flat black paint or chalkboard paint (I’ve found flat works just as well)
Instructions
- Paint the base. Coat all the surfaces – print and frame – with white enamel interior paint (craft paint would work too).
- Paint the inside of the frame (the print area) with flat black paint (remember, there’s no need for chalkboard paint, unless you have it on hand).
- Paint a black edge. At first I thought I could free-hand this with a small brush as shown. Um, no. You can see how rough it is which was too much imperfection even for me, believe it or not. This was better: use painter’s tape and tape the whole frame edge, except where you want the black edge. Just make sure to remove the tape while the paint’s still wet, and touch up in places if you need to.
- Condition. After the paint is fully dry and cured (a day or two), condition the painted surface to write and erase better with chalk. It also gives it that chalkboard look. Use the edge of a piece of regular chalk and rub it all over the surface, then wipe it off with a rag which leaves a film of chalk.
- Print out the letters you want in a font that replicates the look you’re going for. RH signs have C’s, D’s, E’s and F’s, but our last name starts with a B so I used that for the main letter. I used a free font called Lastwaerk in size 550 for the single letters and 450 for the double set. For the streets, the font is the basic Arial Narrow in 150. These sizes worked for my sign that was 11″ wide total, with a chalkboard size of only 7″ – you will need to adjust the sizes to fit the framed print you find.
- Transfer letters to chalkboard by rubbing the back of the printed-out letters with chalk, placing them evenly on the chalkboard and then using a pencil to trace the outlines.Sometimes when you’re making a chalkboard out of something else, regular chalk doesn’t work as well on it (one of the reasons why I used chalk marker for the coloring), and the transfer came out very faint.But it was visible enough to trace around it, and that’s all I needed (it goes without saying, probably, that if you are an artist you can skip all this and free-hand the letters – and I bow to you!).
- Fill in the outlines with chalk or a chalk marker. Since the signs that inspired mine were high contrast, I wanted the same look which I knew I’d get with chalk markers. Plus, they work on almost any surface, even the slightly bumpy surface of my painted-over print.
